Water Lines - Park Models
Water Distribution System
The fresh water distribution system is supplied by a 3/4 inch inlet connection identified by a tag. The system is designed so that little or no maintenance is required for proper operation. The hot water system may be adjusted to the desired temperature control device located on the water heater (see water heater instructions for proper adjustment procedures). The water heater is equipped with a temperature/pressure-relief valve set to relieve excessive temperatures and/or pressures should malfunction occur with the water heater controls. Consult an authorized dealer if water heater service or parts are needed.
In cold climates, all exposed water piping must be protected from damage due to freezing. Many owners accomplish this by means of electric heaters (heat tapes) and insulation. Both may be purchased at most hardware and department stores in a variety of lengths and types. It is important that the heat tape and insulation be installed according to the manufacturer's instructions.
Any heat tape installed should be listed for manufactured home use by a national testing laboratory such as CSA.
In cold climates, the water lines are routed in the floor adjacent to the heat duct. Failure to operate the furnace for heating of the home may cause the water lines to freeze.
If the home is to be unoccupied for extended periods during cold weather, the entire water systems (including water heater and toilet) should be drained. Ensure that the water heater hear source is shut off prior to draining. It is very important that the procedures outlines in the water heater operating instructions be carefully followed. Be sure not to turn the water heater on until the heater is completely filled with water; as damage may occur to the heating element.
Water Line Burst
A water line can burst due to a number of reasons, such as a loose joint, freezing, etc. and should be dealt with immediately. If the burst occurs between a fixture and a shutoff valve, close the shut-off immediately. If no shut-off exists, locate the main water shut-off located on the green box electrical and water connection box outside your park model, and turn it off until the problem can be repaired. It is also advisable to turn off your hot water tank to prevent overheating while the water supply is shut off.
Plugged Fixture or Sewer Line
This generally occurs because of inappropriate materials being flushed down a toilet or drain by users of the facility. Do not continue use of toilets or sinks once a major blockage has occurred. Attempt to unclog the line using a plunger. If a larger blockage occurs, the services of a plumber may be required. If the blockage is due to a proven manufacturer defect then the builder will take full responsibility for the problem.
If the plug appears to be caused from a connection of your park model to the site services connection, please contact Chemainus Garden RV Resort Ltd.
Minor Plumbing Leak in the Line or Hot Water Tank
Put a container under the leak and contact your VI Modular Homes. If major leakage occurs at the hot water tank, immediately shut off the water supply as well as the gas valve or electrical breaker.
Frozen Water Line
If garden hoses are left attached to hose bibs during the winter, freezing of the water line can occur. This is problematic once the pipes thaw as they may leak. If a major leak occurs, follow the steps described above regarding “Water Line Burst”. If accessible, heating the pipe with a hair dryer may thaw it out. If the frozen pipe is due to a proven builder defect, the manufacturer will take full responsibility for the repair.